nimitzbrood (nimitzbrood) wrote,
nimitzbrood
nimitzbrood

Picked up my enameling kiln today!

After many delays on both sides I managed to get together with mashblock and swap an unknown rack mount amplifier for the kiln. I think the trade went well enough. ;-)

Pictures:

http://www.flickr.com/photos/49991043@N00/sets/72157626868149735/

According to what I can find on the web this kiln is a Fire*Brite Copper Kiln and maxes out at around 1600 degrees. With some inserts I can easily make it more efficient. Even if it only goes to about 1200 or so I can still do copper PMC in it along with the enameling the firing times would just be longer.

AND there are _two_ of those baskets of powders.

mashblock I can't thank you enough! :-)

Cross-posted from Dreamwidth ( http://nimitzbrood.dreamwidth.org/232949.html ) but feel free to comment here as well.
Subscribe
  • Post a new comment

    Error

    Anonymous comments are disabled in this journal

    default userpic

    Your reply will be screened

    Your IP address will be recorded 

  • 5 comments